It’s summertime which means outdoor celebrations and an opportunity to make a Father’s day gift for that special man in your life!
You’ll need the following supplies for this project:
1 x 6 ” red wood board
bottle opener
galvanized bucket
ruler
pencil
10 x 1 oval Phillips sheet metal screws x 2
10 x 3/4″ hexagonal sheet metal screw
nut driver
drill
saw
1. Cut your red wood so that it is 2 feet in length.
2. Sand your red wood.
3. To find the spot where your bottle opener will go, measure 2 inches from the top and …
4. 2 and 3/4″ from the sides and place a dot with your pencil.
5. Use a drill and drill a pre-hole where your screw will go. We used a 3/32nd drill bit.
6. After having your top hole ready – place the top bottle opener hole over the pre-drilled
hole and drill into place using your 10 x 1 oval Phillips sheet metal screw.
7. Center up the bottom hole, 2 and 3/4″ from the sides.
8. Use a drill and drill a pre-hole where your screw will go. We used a 3/32nd drill bit.
9. After having your bottom hole ready – place the bottom bottle opener hole over the
pre-drilled hole and drill into place using your 10 x 1 oval Phillips sheet metal screw.
10. Measure 8 inches from the bottom and 2 and 3/4″ from the sides and make a pencil
mark. Pre-drill a hole where your next screw will go.
11. Using a nut driver, screw in your 10 x 3/4″ hexagonal sheet metal screw.
12. Place your bucket on the hexagon screw and you’re done!